Kangaroo 2, OnCurve or MagnetSnap? Or...

Hello there,

I am attempting to use Kangaroo to test / manipulate an array of Hypars (Hyperbolic Paraboloids). Obviously for multiple inputs to act as one in Kangaroo they need to share points...Only the four corners of each module bind to the next in the array but I would like the [blue]lines within the [white] edges of each module to act as though they were tied or bound to the [white] edges of each module. I have looked into OnCurve and MagnetSnap but no joy. Any suggestions?

(Img01 and definition are slightly different, Image indicative for clarity.)

Thanks,

Simon

Attachments:

Hypar Array.gh, 13 KB

Replies to This Discussion

Permalink Reply by Kyle Faulkner on November 25, 2015 at 3:17pm

Are those lines needed for the Kangaroo simulation? In the attached script they are just drawn in after the calculation on the new form.

Attachments:

HyparArray.gh, 20 KB

Permalink Reply by Simon on November 25, 2015 at 5:55pm

Thanks for your quick response and input

Unfortunately so, somehow I need those lines to 'attach' to the midpoints of each edge line so that the new form is similar to the input (plus gravity and the option to change anchors etc)

RSS