Grasshopper

algorithmic modeling for Rhino

Joining multiple topo surfaces

Hi Everyone, 

I am working with a site that lies in the intersection of four SRTM data plots. I managed to get the topo surface for each plot but cannot figure out how to line them up and join them into one surface. Any help would be appreciated. 

Thanks 

I-15%20Topography.gh

Views: 340

Replies to This Discussion

Permalink Reply by Claire Pepper on September 12, 2018 at 8:01am
-also, just to note that SRTM plots seem to overlap a bit so baking and moving the surfaces does not work.
Permalink Reply by Anton Dizon on September 18, 2018 at 6:34am

Hi Claire,

I would suggest getting the Points output from the Elk Topography component and use a Surface from Points component to reconstruct a single surface. The duplicate points generated might need some clean up though.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service