Joining Adjacents Surfaces

Replies to This Discussion

Permalink Reply by Yoann Mescam (Systemiq) on December 11, 2011 at 12:33pm

Brep Join, adjust rhino tolerance if it fails.

Permalink Reply by KrispyKrem on December 11, 2011 at 12:38pm

tried it already (brep) doesnt work, how do you adjust the rhino tolerance?

Permalink Reply by Yoann Mescam (Systemiq) on December 11, 2011 at 12:46pm

Tools->Options->Units-> Absolute tolerance, rise it.

Depends what your surfaces look like though.

Permalink Reply by Pieter Segeren on December 11, 2011 at 12:45pm

I think you should create a new surface, because by joining you would end up with a polysurface(Brep).

Permalink Reply by KrispyKrem on December 11, 2011 at 12:51pm

just figured a way by taking my edges only ... all the others didnt work -_-

thx n e ways