Grasshopper

algorithmic modeling for Rhino

Joined Perimeter curves of multiple surfaces

Perhaps someone can shed some light onto my predicament.

I have multiple surfaces which share edges i would like to extract there perimeter curve, however this curve needs to be joined in order to run the containment component. The Brep Edges does not provide the closed curve result. Anyone have any ideas?

Thanks

Alex

Views: 1363

Replies to This Discussion

Permalink Reply by Pieter Segeren on December 27, 2011 at 1:25pm

Hi Alex, Join the surfaces into a Brep/polysurface and than use the Brep Edges, top output are the Naked Edges (En), Join these too:

Permalink Reply by Alex Worden on December 27, 2011 at 1:29pm

Holy shit dude, you are everywhere. Just as I was writing a response to one of your solutions on another guys post you post here. Thanks very much!

Permalink Reply by Pieter Segeren on December 27, 2011 at 1:36pm

LOL:) Good to hear you are using the search function! And you're welcome.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service