algorithmic modeling for Rhino
Hi
I am trying to select a bunch of curve based on their area, I tried selecting them using a boolean operator a dispatch then a list item component but GH fails to find the proper curves.
I am not sure if these are the rights commands to use, I am including the definition, any help is welcome.
thanks
Tags:
I didn't know this one, exactly what I needed thank you.
Just Connect Cir-C(out) to Dispatch-L(in).. and delete List Item..
nice, i was trying to do the same thing the other day.
i was trying to do both an area filter and a bounding box X and Y control for removing sliver shaped curves from a selection. I can't count on area to work all the time, that's why I need the bounding box X, Y controls I think.
how would you go about working that into it?
thanks,
ryan
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by