Grasshopper

algorithmic modeling for Rhino

Item selection with boolean

Hi

 

I am trying to select a bunch of curve based on their area, I tried selecting them using a boolean operator a dispatch then a list item component but GH fails to find the proper curves.

 

I am not sure if these are the rights commands to use, I am including the definition, any help is welcome.

 

thanks

Views: 4209

Attachments:

Replies to This Discussion

Permalink Reply by Chris Tietjen on December 7, 2011 at 6:29pm

Try this.

Chris

Attachments:
Permalink Reply by Sam75 on December 8, 2011 at 2:36pm

I didn't know this one, exactly what I needed thank you.

Permalink Reply by Jissi Choi on December 7, 2011 at 7:11pm

Just Connect Cir-C(out) to Dispatch-L(in).. and delete List Item..

Permalink Reply by Sam75 on December 8, 2011 at 2:42pm

Thank you

Permalink Reply by kleerkoat on December 8, 2011 at 6:42am

nice, i was trying to do the same thing the other day. 

i was trying to do both an area filter and a bounding box X and Y control for removing sliver shaped curves from a selection.  I can't count on area to work all the time, that's why I need the bounding box X, Y controls I think.

how would you go about working that into it?

thanks,

ryan

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service