Grasshopper

algorithmic modeling for Rhino

is there still a merge bug in the beta?

I'm trying to merge five sets of six points, where each point is on its own branch ({0}, {1}, {2}, {3}, {4}, {5}), and item 0 is coming up on branches all branches of the merge except {0}. All 6 entries in List 0 reference the same point, and are not null as you can see.

I haven't been able to find any workarounds. I thought it was a referencing problem, so I tried decomposing the point, recomposing it, duplicating it six times, grafting and putting those into the merge, but I got the same result.

Views: 208

Attachments:

Replies to This Discussion

Permalink Reply by Manuel on October 28, 2009 at 6:25pm
if the merge component is the problem, try this: replace the merge component and use a empty pt component, then connect in order all the points while you press down the shift key.
Permalink Reply by Andy Edwards on October 28, 2009 at 9:34pm
Yeah, that might work...although I might expect it to use the same code. I finally got around it by using 4 merge 2 components.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service