Grasshopper

algorithmic modeling for Rhino

Irregular Brick Pattern

Hi guys, i'm new to Grasshopper and I need help with a pavement pattern for a project.

The pattern should be something like the image. Regular size bricks in the Y axis but irregular in the x axis. I want it to be parametric in way that I can change the size of the Y axis(regular) and the irregular bricks regenerate in the surface.

I've managed to get to dividing the horizontal line into random points but I can't make each line be evaluated differently, so, they're all the same. I'm sending the grasshopper file I've got so far.

Views: 2690

Attachments:

Replies to This Discussion

Permalink Reply by FRiou on June 15, 2015 at 5:32am

Hello Tiago!

Sorry I did not open your file, but here is how I would do such a pattern.

Know that the Random component works with a Seed input : ie for a same range, if you ask three times for ten random numbers, you will always get the same ten numbers unless you provide three different seeds.

I hope it helps. Good luck!

Attachments:
Permalink Reply by Tiago Casini on June 15, 2015 at 9:34am

FRiou,

Thank you so much! Didn't even needed your file, just the explanation that I needed each seed for each point was enough! It worked perfectly.

Thank you very much.

Tiago.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service