Grasshopper

algorithmic modeling for Rhino

invert the direction of rectangles

Just a simple question: I have to put some rectangles with a base point but i would like to invert the direction of the rectangle..

this is how it looks like if I use the Rectangle tool putting the starting points.. just imagine that the actual direction of the rectangle is Y and it's positive

If i would like to draw that rectangles in the Y negative direction (the opposite direction), how can I do that?

Views: 453

Replies to This Discussion

Permalink Reply by nikos tzar on December 5, 2014 at 4:31am

Hi Matteo,

you will have to plug a negative number into Y.

Permalink Reply by Matteo Persanti on December 5, 2014 at 4:38am

Ah! It was that much easy! Thank you Nikos!

Permalink Reply by Daniel González Abalde on December 5, 2014 at 4:38am

As a supplement, you can adjust the start of any curve with Seam.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service