Intersection doesn't work propertly!!!

Replies to This Discussion

Permalink Reply by TiM on January 22, 2010 at 1:45am

This is what i get

Permalink Reply by David Rutten on January 22, 2010 at 2:44am

Tim,

looks like the mesher is getting confused. Grasshopper most likely uses different meshing settings than your Rhino document, so if there's a discrepancy, it's probably due to this difference.

If you post the actual geometry, we can have a look at why it is meshing incorrectly.

--
David Rutten
david@mcneel.com
Poprad, Slovakia

Permalink Reply by TiM on January 22, 2010 at 4:31am

Hello, David. I don't understand you. What geometry? I've attached my def - that's all i have. This geometry was made from the GH cilynder...

Permalink Reply by luca.pavarin on January 22, 2010 at 5:43am

You need to increase your mesh setting!

Permalink Reply by TiM on January 22, 2010 at 5:57am

are you talking about the amount of faces of this geometry or what?

Permalink Reply by luca.pavarin on January 22, 2010 at 6:05am

In Rhino, go to: Tools -> Options -> Mesh, and change the render mesh quality (custom).
It should work!

Permalink Reply by TiM on January 22, 2010 at 7:44am

Luca, you are my savior! Everything works!!!! Thank you, Luca! Thank you, David! Good luck to you!