Intersection component

Replies to This Discussion

Permalink Reply by David Rutten on June 23, 2014 at 7:33am

You create planes from a full circle, so you have two opposing planes on each side. Thus you get duplicated intersections.

If you only want to create a single intersection per vertical slice, you have to make the slices non-infinite. I.e. instead of Planes, you should use surfaces (see attached)

--

David Rutten

david@mcneel.com

Attachments:

• Courtin2.gh, 13 KB

Permalink Reply by Verônica Natividade on June 23, 2014 at 7:37am

Thank you, David!