Intersecting vector with a mesh

Replies to This Discussion

Permalink Reply by ng5 Alex on December 5, 2014 at 5:07pm

you are correct, using the mesh curve intersection component i get 2seconds calculation instead of 6.3 with brep curve.(old laptop)

Permalink Reply by djordje on December 5, 2014 at 5:51pm

Yes, you are right, the solution with meshes is by far the fastest one.

Attachments:

• attempt3_3.gh, 22 KB

Permalink Reply by ng5 Alex on December 5, 2014 at 5:00pm

still 2 times is an improvement.

yes, i remeber in a post David explaining why it is difficult, if not impossible, for some components, but many are going to be MT. lets wait and see

Permalink Reply by Apoorv Goyal on January 13, 2015 at 3:41pm

Djordje, 

I have a question related to the definition you wrote. These are primarily for me to understand python. 

def intersect(_meshVecTupleL):
_m, _pt, _v = _meshVecTupleL
ray = Rhino.Geometry.Ray3d(_pt,_v)
length = Rhino.Geometry.Intersect.Intersection.MeshRay(_m,ray)
print length
if length < 0.0:
lines=Rhino.Geometry.Line(_pt,_pt+(100*_v))
return lines

if Run == True:
if parallel:
meshVecTupleL = []
for pt in points:
for v in vectors:
meshVecTupleL.append((mesh, pt, v))
withNulls = ghpythonlib.parallel.run(intersect, meshVecTupleL, True)
a = [item for item in withNulls if item != None]

1. How come we never defined length as an empty list and still it stored all the numbers? 

2. If length < 0.0 , lines are being created. How does python/rhino knows which pt to make the line at since we are processing the entire list "length" ? 

3. If I add another statement before return lines that would return the startpoint of the line instead of the line itself, it doesn't work. Why is that? 

Thanks for your help. 

Permalink Reply by djordje on January 16, 2015 at 7:15am

Hi Apoorv,

1. length is not a list. It's a variable, and it stores a value which Intersection.MeshRay returns. Intersection.MeshRay always returns a single value not a list

2. if length is > 0.0 the ray intersects the mesh at length point along that particular ray. Similar to evaluating a point on a line/curve at particular parameter.
if length is equal to 0.0 the point from which the ray starts, sits on the mesh.
if length is < 0.0, then there's no intersection between the ray and the mesh, which is exactly what you wanted - so in that case for the sake of visualization we are creating lines from those rays.

3. It works here. Check the attached file.

Attachments:

• attempt3_4.gh, 90 KB

• ‹ Previous
• 1
• 2
• Next ›
• Page