Intersecting Radial Curve

Hey Guys,

I have this simple condition where i want the curves to radiate from the centre of the rectangles to an outer rectangle. As u can see i get a lot of intersection within the rectangles themselves which i want to get rid of. Can anyone help me..

Thanks

Attachments:

4.jpg, 555 KB

Replies to This Discussion

Permalink Reply by David Rutten on April 10, 2010 at 5:57am

Hi Tushar,

how do you want to get rid of them? I don't fully understand what the result is you have in mind. Could you post a picture of that?

--
David Rutten
david@mcneel.com
Poprad, Slovakia

Permalink Reply by Arthur Mamou-Mani on April 10, 2010 at 12:13pm

Hi David,
I have worked with Tushar on that:
we were wondering how we could tell grasshopper to delete the lines going through other rectangles from the list.
Then we were wondering how to replace them, in the same list, with only the first segment of each line before they enter another rectangle.
Basicaly like a trim which would only keep the segment towards the center of the initial rectangle from which the line radiate.
i hope this makes sense....
cheers,
arthur

Permalink Reply by David Rutten on April 10, 2010 at 4:43pm

You may have to use a Curve Intersect, then count the number of hits you get. If it's zero then your line can stay, if it's one or higher you want to cull it. Would an approach like that work?

--
David Rutten
david@mcneel.com
Poprad, Slovakia

Permalink Reply by Tushar Sharma on April 10, 2010 at 5:06pm