Grasshopper

algorithmic modeling for Rhino

Hi everyone,i want to interpolate a few curves and then create a surface using the network surface component.The first problem is that i am having an error(orange balloon) at the curve inerpolation component saying "Interpolation does not allow even degrees". My second problem is that when i connect the U and V curves,which i interpolated as 3rd degree curves,with the network surface component the result is null(no surface),even though the component does not turn into red or orange colour. I don't know if the second error is due to the first one and i would like to hear any opinions on these two problems.Thanks

Views: 813

Replies to This Discussion

Thank youTom for your reply but i think the null surface problem is caused by other reason,by the way i've already flattened my data so that's definitely not the problem.Anyway i will post my GH file in the next days so i hope that this will be more helpful.Thanks again..

RSS

About

Translate

Search

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service