interpolated curve problem

Replies to This Discussion

Permalink Reply by °[u on July 10, 2009 at 6:24am

hi Caglar!

wave pattern: 0 and 6 are the same points.... that's the problem!
don't use the 6. point....
disconnect point 6 and then right mouse click on the interpolated curve "p"- Set Boolean -> True

best
[u

Permalink Reply by Caglar on July 10, 2009 at 8:04am

thanks!
i tried the periodic curve and wasn't satisfied. i didn't think of removing the 6th input though.
but as you can see it is still not what i want to achieve. the black curve is drawn in rhino from the same set of points and same order. is there any way of getting the same one in grasshopper? otherwise when i polararray the curve, they overlap.

Attachments:

• int_crv_tangency2.jpg, 400 KB

Permalink Reply by °[u on July 10, 2009 at 8:51am

hi,

i know your porblem... i think it is currently impossible with the grasshoppercomponents...
try my vb_component... i used "RhUtil.RhinoInterpCurve"
you can experiment with the knot_style (same to rhino)->
the look of the curve will change (best solution with knot_style=4)

good luck

[u

Attachments:

• Rhino_intCV.ghx, 30 KB

Permalink Reply by °[u on July 10, 2009 at 8:53am

and sorry... now you 'll need the 1. point (0) as the last point (6) ;-)

Permalink Reply by Dirk Anderson on July 13, 2009 at 3:01am

right click the U input on the bBox component and set to true.

Permalink Reply by Caglar on July 14, 2009 at 7:03am

*blushes

Permalink Reply by kleerkoat on July 15, 2009 at 7:03am

that is really cool, I like that a lot.

i would love to have a peak at this definition if you are ok with sharing it?
thanks.