Installing modules

I have python xy installed, but Rhino is not able to access its modules. How can install pylab and other libraries/modules such that rhino can access them?

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on May 23, 2013 at 2:30pm

I assume you only need to add the path to GHPython component. try something like this:

import sys

sys.path.append('pathToWhereLibrariesAre')

import 'yourLibrary'

Permalink Reply by Anders Holden Deleuran on May 24, 2013 at 2:35am

Adding to what Mostapha said, you can also add module references using the Rhino Python editor. These references will carry over into the Python Grasshopper component. Also, note that not all Python modules are supported by IronPython (which is the Rhino flavour).

Permalink Reply by Garrett Milliron on May 24, 2013 at 4:33am

In the thread you referenced it looks like someone was able to successfully import numpy, but when i try after adding the site packages folder it give me a message: No module named multiarray

Permalink Reply by Anders Holden Deleuran on May 24, 2013 at 4:45am

I have not tried this myself, but check out Steve's explanation here. Unfortunately it seems that there is still no 64bit version of Numpy and Scipy yet though..

RSS