Installing Geometry Gym Plugins

If you have problems installing, there is instructions outlined here:

http://www.geometrygym.com/installing

If you have problems, please either email me, send me a message through this ning or post to the forum below and I'll be glad to help.

If you're behind the firewall in China and cannot access the downloads, please email me and I will send you a link to a dropbox shared folder.

Replies to This Discussion

Permalink Reply by an@mation on October 15, 2011 at 9:51am

thanks jon

Permalink Reply by Zhang Bin on December 8, 2011 at 3:24am

Hi,

I aleady installed this pulgin ,everything are looks like be ok. however, in the grasshopper can't running the GeomGymBIm.

Permalink Reply by Jon Mirtschin on December 8, 2011 at 4:02am

What does is show if you hover your mouse over the Red cloud on the top right hand corner?

If you run rhino command GrasshopperDeveloperSettings and untick COFF loading, restart Rhino does it resolve the error message (it will be something about initialization if this is the case).

I'll help further as needed.

Permalink Reply by Zhang Bin on December 21, 2011 at 2:16am

Permalink Reply by Zhang Bin on December 21, 2011 at 2:17am

Actually,my syetem is CHI. Thanks for your kinds

Permalink Reply by Jon Mirtschin on December 21, 2011 at 3:38am

To me the most obvious cause is the COFF loading issue, if I tick the box below I get similar (but not identical) errors to you.

Can you please confirm when you run rhino command GrasshopperDeveloperSettings the box is unticked as per below? If not, please untick it and restart Rhino/Grasshopper.

Permalink Reply by to] on December 21, 2011 at 5:00am

Hi Jon,

GH08.0063 newest struct draw

An error occured during GHA assembly loading:
Path: C:\Program Files (x86)\Rhinoceros 4.0\Plug-ins\SSI\sdrGH.gha
Exception System.TypeLoadException:
Message: Could not load type 'MaterialTypes' from assembly 'ssiStructDrawRhino, Version=0.8.21.0, Culture=neutral, PublicKeyToken=null'.

Permalink Reply by Jon Mirtschin on December 22, 2011 at 4:46am

Hi Tom,

As we discussed on skype, it seems from your message above referencing 0.8.21.0 that the installer hasn't successfully updated all files. Uninstalling from control panel (or deleting the SSI folder) and reinstalling should get you running again.

Cheers, Jon

Permalink Reply by Zhang Bin on December 21, 2011 at 7:41pm

Hi,the same errors like above.I have send LicenseRequest to your email.

Permalink Reply by Jon Mirtschin on December 22, 2011 at 4:47am

That's an expected error message, and the license file in the email I sent you just before will resolve this. Let me know if you want further help when you get this running.

Permalink Reply by Zhang Bin on December 22, 2011 at 11:06pm

Hi Jon,

Everything is be ok.Tanks a lot.

Permalink Reply by shao,yan on March 5, 2012 at 12:33pm