Input several gh-generated curves in Curve parameter

I try to make by myself an algorythm I found on web, and there is a part I can't perform.

On the picture I found multiple grashopper-generated curves connect with Curve parameter in the same time, but I can connect just one curve with this parameter. When I try to attach another one, the first connection disappears.

What should I switch on or off to make Curve parameter able to receive multiple grasshopper-generated curves?

Thank you.

Attachments:

koch-snowflakequest.png, 157 KB

Replies to This Discussion

Permalink Reply by David Rutten on December 24, 2014 at 12:48am

Hold Shift while connecting.

Permalink Reply by Lyubov Timofeeva on December 24, 2014 at 4:59am

Thank you)

Permalink Reply by Igor on December 24, 2014 at 1:15am

...плюс ко всему, что сказал Дэвид, не обязательно столько раз выводить List Item. Если его приблизить, то появятся плюсики на выходах, с помощью которых можно добавит столько выходов (последующие элементы списка), сколько необходимо. Не будет загромождать скрипт.

Permalink Reply by Lyubov Timofeeva on December 24, 2014 at 5:00am

Спасибо за совет. Пока я пытаюсь повторить исходный код

RSS