Image Sampler with Boxes

Hi everyone,

I have a question about using the Image Sampler. I know that you can limit the size of a shape that is being manipulated by the Image (so boxes or something won't overlap). Is there a way to Cull a list or something related so that if the box width is less than 1 or something that it isn't included? I'm eventually going to make a model of this and if the boxes are too small I won't be able to build them. See image below.

Thanks,

Jamie

Replies to This Discussion

Permalink Reply by idPlaNo on April 25, 2012 at 11:55am

I wonder the same thing

Permalink Reply by Michael Pryor on April 25, 2012 at 3:11pm

use a maximum component, which will make sure no box is aloud to exceed a specific size, or a less than component which will give a true/false pattern for cull pattern, or remap component and remap the values to your desired domain.

Permalink Reply by David Rutten on April 25, 2012 at 2:27pm

The image sampler only samples. The Cull components cull. You're going to have to use a combination of these two to achieve your goals. After you make your boxes, measure them and remove the ones you cannot fabricate.

David Rutten

david@mcneel.com

Poprad, Slovakia

RSS