Grasshopper

algorithmic modeling for Rhino

Image sample circle prolem

Hi guys! I try to use image sample attractor the circle, But now have some problem

* a Surface divide and isotrim, use Scanle NU to control range,But image sample just to effect every trim surface.I hope this sample effect whole surface.

* The same applies use to cylinder, can't no generate axis plane, how to do?

* The method for improving the work efficiency of suface split?

Sorry about my english,THX!

Views: 915

Attachments:

Replies to This Discussion

Permalink Reply by lucas cañada on August 21, 2013 at 9:54am

Hi Jacky. Nice to see you again!! Try this deff. You shouldn´t divide surface, and you can obtain planes for your circles on cylinder under evaluate surface component. (F output). See you. ;)

Attachments:
Permalink Reply by JackyCheung on August 21, 2013 at 1:20pm

Hi Lucas, Glad to see you too, Thank your help~!!! My english is limited, so cannot express my idea. ;)

Maybe this picture explain it, help me :(

Permalink Reply by lucas cañada on August 21, 2013 at 3:07pm

Nice explain this time...;)

Attachments:
Permalink Reply by JackyCheung on August 22, 2013 at 3:25am

Thanks Lucas, You get me a best instructor, Is a better way to start probe, I must continue to learn if I am to make further progress. Thanks. ;)

(PS: Grasshopper no support mulitcore cpu, so low efficiency of SurfaceSplit, is lengthy to Parameter calculation process... ... :(

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service