Grasshopper

algorithmic modeling for Rhino

if statement for curve degree

is it possible to make a grasshopper component that filters curves with their degree values? works like;

takes curves as input, filters them with their degrees (1 and rest would be fine for me also) and give them from different outputs. and an another output that says what curve is what degree.

thanks in advance

Views: 428

Replies to This Discussion

Permalink Reply by David Rutten on September 28, 2016 at 3:02pm

I'm surprised there's no component which outputs the curve degree, but you can calculate the degree by subtracting the control-point count from the knot count and adding 1.

Attachments:
Permalink Reply by deli dumrul on September 29, 2016 at 5:25am

thanks, that's working perfectly.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service