Grasshopper

algorithmic modeling for Rhino

Identification of duplicated points

Hi. ALL. I know that there is Remove duplicate points>> component in Kangaroo but is there any way that I can identify the location and number of duplicated points before removing it? I would like to use the number of duplicated point as a parameter to affect the geometry. Please respond me.

 

Kwanphil

 

Views: 862

Replies to This Discussion

Permalink Reply by Jacek Jaskólski on December 9, 2011 at 1:59pm

a general solution, not only for points:

Attachments:
Permalink Reply by kwanphil cho on December 9, 2011 at 2:30pm

Thanks a lot. It is working nicely. I didn't know that CreateSet>> component is removing duplicated points and extract only base points. Really appreciating your quick response.

 

Permalink Reply by Vicente Soler on December 9, 2011 at 2:53pm

You can achieve the same thing connecting directly the member index to the create set component.

Permalink Reply by kwanphil cho on December 9, 2011 at 5:06pm

Can you explain little bit more in detail, please? thanks in advance.

 

Permalink Reply by Jacek Jaskólski on December 10, 2011 at 12:24am

As Vicente pointed out, you can actually simplify it like this:

Attachments:
Permalink Reply by Alpha222 on December 10, 2011 at 12:49am

I think this is what Vicente mean:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service