I can't manage to offset surface whatever i do...

Replies to This Discussion

Permalink Reply by Jerrimo on July 12, 2010 at 3:52am

http://www.grasshopper3d.com/forum/topics/offset-problem

Permalink Reply by oğuz emre bal on July 12, 2010 at 4:30am

i think i create the vektor and it connected to "move". than it become two curves which are diffrent in Z axes. than i lofted tham and make a surface. the problem is started after i tried to offset this surface. "Offsetsurface" is not inherited somthing from surface source.

Permalink Reply by oğuz emre bal on July 12, 2010 at 5:25am

and also i found out that when i use multiple curves by exploding the orginal curves and make surfaces by using this curves i can offset the surfaces (and it also intersects each other like picture).

Attachments:

• 123.png, 182 KB

Permalink Reply by oğuz emre bal on July 12, 2010 at 6:20am

i found something to, when i make a polysurface which contains folding edges...

Permalink Reply by oğuz emre bal on July 12, 2010 at 6:27am

yep its about polysurfaces... is anybody know how we offset the polysurfaces

Permalink Reply by Jerrimo on July 12, 2010 at 6:27am

hey oguz emre bal,
i think you should first offset the curve, then loft them and then you can extrude them in z direction. Good luck

Attachments:

• wall.png, 185 KB

Permalink Reply by oğuz emre bal on July 12, 2010 at 6:48am

damn!!! i tried hours and found the problem... the curves doesnt exist in the same plane. thanks for replies:)