how to turn a Brep into a Surface?

Replies to This Discussion

Permalink Reply by taz on March 17, 2010 at 9:25pm

A BRep is the equivalent of a polysurface.

If you [Explode] your BRep it should give you the constituent surfaces.

Permalink Reply by Suryansh Chandra on March 18, 2010 at 5:36am

A polyline, or a polycurve (a curve with non-continuous segments) would always generate a Brep/polysurface on extrusion, not a surface. So either you deal with them as multiple surfaces for each curve as Taz suggested, or you make your curves in a way so that there are no tangential discontinuities.