Grasshopper

algorithmic modeling for Rhino

How to start from a point perpendicularly and not the inverse?

Hello,

I'd like to make a grid on topolines.

It doesnt work weel the the closest point on a curve command. I get some trouble when the curves are too concaves or too convexes.

I'd like to try by leaving perpendicularly my point to touch the next curve instead of arriving perpendicularly on this next curve ?

Someone knows a solution by chance?

thx a lot

Mick

Views: 397

Replies to This Discussion

Permalink Reply by Michael Pryor on November 20, 2012 at 10:53am
Wrong area, If you put this into discussion forum you will get more results. FAQ is for people to go to to see solved frequently asked question
Permalink Reply by Mick4Grasshopper on November 21, 2012 at 10:02am

thanks for moving it!

Permalink Reply by Michael Pryor on November 21, 2012 at 11:22am

I haven't moved it. You have to :)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service