Grasshopper

algorithmic modeling for Rhino

how to rotate the object in one point box

i am trying to make this kind of masonry bond in GH. Anyone can help me for rotation of brick in center point of box and how can i make it in a grid papptern if i want to change lenght aand width of entire wall. help me

thanks in advance

Views: 915

Attachments:

Replies to This Discussion

Permalink Reply by shreyas on May 1, 2016 at 9:19am

please see attched picture and gh file

Permalink Reply by Jennifer Lane on May 1, 2016 at 9:04pm

I've edited your file to allow for your grouped module to rotate at the center instead of the corner. You just needed to specify a point for the plane in the rotation component. The point was found by evaluating the surface of one of the boxes. Now you can move your rotated module to where you need it. 

Attachments:
Permalink Reply by shreyas on May 2, 2016 at 12:53am

thanks a lot... i need one more favour. how can i make a grid of that objects i wanted to make a wall in it. see image for refrance. thanks

Attachments:
Permalink Reply by shreyas on May 7, 2016 at 11:06am

 Jennifer Lane would you help me in this issue please.... thanks in advance 

http://www.grasshopper3d.com/forum/topics/doubt-in-objects-in-grid-1

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service