How to make Space frame?

I am hoping to form a space frame on a surface that I have drawn on rhino. I'm almost there, it's just that I want to join the mid points that I have moved from each surface division. I've tried to item the set of points to join but no luck...

I have attached an image of my file, the highlighted points are the ones I moved. Any suggestions on how I could join them to form a grid would be much appreciated. Thank you.

Jisoo

Attachments:

space frame midpoint.png, 535 KB

Replies to This Discussion

Permalink Reply by Sebastian L. on May 9, 2012 at 10:43am

maybe this link helps you:

Digital Toolbox Spaceframe

Permalink Reply by Michael Pryor on May 9, 2012 at 10:44am

interpolate curve the points, then flip matrix the points and interpolate curve the points again.

Permalink Reply by Jisoo on May 9, 2012 at 11:08am

Thank you for the response. Is it possible to connect the interpolate curve onto the move component? I've attached another image.

Attachments:

space frame midpoint 1.png, 358 KB

Permalink Reply by Michael Pryor on May 9, 2012 at 11:22am

G of move should be in V of interpolate curve (or polyline), then G of move should also be in a FLIPMATRIX (not flip) component, then plug the flip matrix into another interpolate curve.

Permalink Reply by Jisoo on May 9, 2012 at 1:42pm

Thanks for the image. I have just tried the method. It works for the one interpolate curve component but the other is in red... Also could you advise me how I could end the curves rather than in a loop. Thanks again.