How to make a shell structure using line

Replies to This Discussion

Permalink Reply by pyrit on April 29, 2014 at 2:25am

hi

how did you get your curves ?

maybe you join them and then sweep (sweep1 component) a profile along each ...

Permalink Reply by pyrit on April 29, 2014 at 3:09am

sorry i cant ...

i get an error if i do perpframe component on a curve...

ups my bad

Attachments:

• tester.gh, 6 KB

Permalink Reply by pyrit on April 29, 2014 at 3:32am

you could join your segments and then use this polyline for building a spline. then extrude along this. but i dont know how the orientation of that spline would be

if its twisting and changing direction you always will get a twistet extrution.

maybe have a look at kangaroo components - lets you generate gridshells that are more physically acurate i think

Permalink Reply by pyrit on April 29, 2014 at 3:21am

maybe a starting point

Attachments:

• tester.gh, 7 KB

Permalink Reply by pyrit on April 29, 2014 at 3:43am

for 3d printing you have to have watertight meshes.

if u have surfaces they have to enclose a volume without holes and so on...

then convert it to mesh via rhino or grasshopper

http://vimeo.com/60897890

Permalink Reply by David Stasiuk on April 29, 2014 at 4:26am

You have a great starting network of lines. if your goal is to make a 3d print, then you should definitely use weaverbird:

Permalink Reply by David Stasiuk on April 29, 2014 at 4:23pm

I didn't save it. Dude, if you can't make this, you shouldn't be asking. :)

Download and install weaverbird...add a curve component, and reference your curves...then just look for the rest of the components in GH. It's just sliders, a panel, and then a few components from weaverbird.