Grasshopper

algorithmic modeling for Rhino

How to LOFT?

hi everybody,

I have to grids with two different Z components and a circle is assigned to each point in each grid.circles in each grid have the same radius but the radius is different in each grid.

i wanna loft each circle in 1st plane to its similar circle in the 2nd grid in orther to have a conic shape, but when i use LOFT, it goes wrong.

how can i use LOFT here?

Views: 244

Attachments:

Replies to This Discussion

Permalink Reply by MARIO VERGARA on July 18, 2012 at 2:37pm

regards

Attachments:
Permalink Reply by Arash Deilami on July 18, 2012 at 2:40pm

thank you very much MARIO

i'm so thankful

regards

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service