How to join a number of plugs to loft component or curve component

Hi Everyone,

I met the problem that I couldn't join a number of plugs to C (curves as list) of 'loft' component or V (vertices as list) of 'curve' component. (Only one plug was available.)

Comparing GH of my PC with that in the reference book I use, these elements of component seem to have changed. (For example of 'Loft' component, S(curve) changed into C (curves as list)

Is this the problem of the new version?

and how can I join more than one plugs to these elements?

My version of GH is September-28.2012 / Build 0.9.0014 and Rhinoceros ver. is 4.0.

Any help would be greatly appreciated.

Attachments:

20121211GH_error.jpg, 93 KB

Replies to This Discussion

Permalink Reply by djordje on December 11, 2012 at 2:31am

Hi Erica,

Joining multiply wires into one input plug has not been changed.
You just need to hold the "SHIFT" button on your keyboard, when you want to plug in the second, third, fourth... wire.

Permalink Reply by Erica Endo on December 11, 2012 at 2:52am