how to group sub-branches into single branch?

Replies to This Discussion

Permalink Reply by Manuel on October 23, 2009 at 1:43pm

http://www.grasshopper3d.com/forum/topics/flattening-a-specific-lay...

Permalink Reply by Ognek Kciroks on October 27, 2009 at 12:37pm

Manuel,
Thank you for the reply. I tried to do as shown in your link but just can't get it right.
Here's my simple attempt to convert {0:0} to {0} using ReplaceBranches, without any luck.
I tried different possibilties with separators but... not working.

Permalink Reply by Manuel on October 27, 2009 at 1:44pm

in the image that you upload, the wing botton receiver has only one branch... ? if you want to convert {0:0} to {0} just use the simplify tree component... or try with the flatten tree component.

anyways, the solution to the original problem:

Attachments:

• group sub-branches - flatten one step down.ghx, 145 KB

Permalink Reply by Theunis du Toit on October 27, 2009 at 1:47pm

"convert {0:0} to {0}"

Just use Flatten component to achieve that affect.