how to create sweep2 with multiple cross-section curves in grasshopper?

Replies to This Discussion

Permalink Reply by Danny Boyes on April 28, 2010 at 10:01am

If you are selecting multiple curves in the normal way and making sure that they are in the same direction. Then the only thing I can suggest is go back to Rhino and double check the direction of the rail curves

if they are the same then reverse the list of section curves as they need to start at the same end as the start of the rails.

Note: using the Flip component on the rail curves in GH, as you say, will not work.

Permalink Reply by Ceason on April 28, 2010 at 10:35am

thank you~ danny boyes
you've been a great help!