how to create a surface with a maximum slope degree from a non-planar curve?

Replies to This Discussion

Permalink Reply by Kalin Ngo on February 27, 2017 at 3:11pm

I'm not entirely sure what you're asking for but perhaps the PATCH component or EDGE SURFACE component might help you? 

Example:

Permalink Reply by Deedi on February 27, 2017 at 4:09pm

Thanks for your help =)

I added an image of perimeter with site topo in head post.

The golden line is perimeter I intersected from green site tope.

And I tried PATCH which is shown in the other image, and got the red outline with surface.

How can I control the slope degrees in the new non-planar surface at the same time? It need to be within 8%.

Permalink Reply by 0ddw589ypu3jv on February 27, 2017 at 7:26pm

It may be solved using galapagos!

Can you upload your file?

Permalink Reply by Deedi on February 28, 2017 at 2:13pm

Sure I have attached it in head post