how to create a surface trough my section profiles

Replies to This Discussion

Permalink Reply by Oliver Dark on June 26, 2016 at 5:56am

5mb

Attachments:

• concert_hall.gh, 7 KB

Permalink Reply by Oliver Dark on June 26, 2016 at 5:57am

5mb

Permalink Reply by Vongsawat Wongkijjalerd on June 26, 2016 at 8:27am

When you say surface, do you mean to [Loft] your section profiles?
Loft is usually pretty good, so long as the curves are ordered properly

Your attached gh doesn't seem to have anything to do with surfaces so I'm somewhat confused though..
Attaching the rhino or internalizing stuff in the gh to make it more clear what your trying to do would help.

Permalink Reply by Oliver Dark on June 26, 2016 at 9:30am

Yes I would like to loft my section profiles. But it doesn´t work. I have a little bit more complex script than usually.

Any other kind of surface woulb be fine too. Thank you.

I attached a new grasshopper and rhino file. I hope it´s better now.

Attachments:

• forum.gh, 7 KB
• forum.3dm, 35 KB

Permalink Reply by Oliver Dark on June 26, 2016 at 9:42am

When I loft it I get these problems.

Attachments:

• Schritt_48.PNG, 573 KB

Permalink Reply by Hyungsoo Kim on June 26, 2016 at 10:42am

Hi.

This is what I've got so far, and after fillet, some invalid curves were generated, so I used "clean tree".

 

Attachments:

• forum_re.gh, 13 KB

Permalink Reply by Oliver Dark on June 26, 2016 at 11:07am

Thank you. That helps a lot!:)