ll

[[

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by peter fotiadis on April 20, 2016 at 11:38am

Oops! this is (a) very easy ... BUT ... (b) takes a week (and a half) to finish (extrude both sides at once [as solid] the BrepFace derived from mapping your drilled brep into some surface).

I'll try the opposite (instead of extruding the BrepFace => map the holes and perforate the OEM brep) but don't expect real-time response (at best: about half a week).

Complex explanations (and the def) soon.

Permalink Reply by peter fotiadis on April 20, 2016 at 12:20pm

I think that Ctrl-Alt-Defeat is not that bad: Rhino is incredibly slow (even with an E5 Xeon 1630 v3 around) when attempting to "thicken" the mapped "drilled" BrepFace.

Hurts to admit it (I hate meshes) ... but the only realistic solution is er ... hmm ... using meshes.

Moral: How had the mighty fallen.

more tomorrow.

Permalink Reply by saikrishna on April 20, 2016 at 1:15pm

OK thanks for helping me in this issue

Permalink Reply by peter fotiadis on April 20, 2016 at 1:37pm

But on the other hand > I hate meshes > more brainwash > solved (using some freaky approach) > fast as my Ducati 1299 > only 4567 milliseconds > As nurbs solid of course (closed Brep) > I hate meshes > thanks but no thanks.

Shown a "partial" map (using a "sub domain" as target, that is) => LOL or what?

And as full map:

The def tomorrow.

Moral: from Zero to Hero.

Permalink Reply by saikrishna on April 20, 2016 at 1:42pm

Hi Peter,
Can u attach the .gh file of it so I can also do some research on it if I found any result I will let u know can u pleasee

Permalink Reply by peter fotiadis on April 20, 2016 at 2:09pm

OK ... but I do hope that you can handle this (still a bit tricky and NOT real-time by any means). This type of stuff has no meaning to attempt // processing, mind.

Although the test surface is internalized ... load R file anyway.

If messy things happen (Rhino fails to internalize things rather frequently) reference again the test surface to the surfTo input.

best

Attachments: