Grasshopper

algorithmic modeling for Rhino

How to create a mesh from surface

Hello, I am new in Grasshopper, and what I tried to achieve was to create a mesh from a surface through data organization, and insert it in Kangaroo. However, the anchor points are on the perimeter and because of the way  the mesh is created, the final quads don´t reach the perimeter and as a result, instead of inputing all the points of the perimeter, kangaroo recognizes only the ones where the quads are on the perimeter. 

I was wondering if there was a more efficient way of organizing the points for creating a mesh that reaches more accurate the perimeter.

Thank you

Views: 1397

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on October 28, 2017 at 8:49pm

Have you ever tried "Mesh Machine"?

Permalink Reply by F L on October 30, 2017 at 3:23pm

Thank you very much for the answer, I have kangaroo installed, however I could not find some components from your definition. Is there a way they can be uploaded? 

Thank you

Permalink Reply by Michael Pryor on October 30, 2017 at 3:36pm

They are kangaroo 2 and mesh machine. 

Permalink Reply by F L on October 30, 2017 at 6:56pm

Thank you very much, I have tried your definition but without success.

Attachments:
Permalink Reply by Hyungsoo Kim on October 31, 2017 at 12:34am

Do not mix components with different versions and use them separately.

Attachments:
Permalink Reply by F L on October 31, 2017 at 10:29am

Thank you!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service