how on earth can i make a surface from these level lines in grasshopper/rhino?

Replies to This Discussion

Permalink Reply by David Rutten on October 31, 2011 at 8:38am

Its metaballs.

 

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Attachments:

• IsoCurveStack.gh, 3 KB

Permalink Reply by Michael Pryor on October 31, 2011 at 9:05am

do you think we will ever see a "cleaner" and "faster" option to skin metaball curves rather than meshfrompoints. Just curious.

Permalink Reply by David Rutten on October 31, 2011 at 3:21pm

3D metaballs at some point. Not very high priority.

 

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Andrei Raducanu on October 31, 2011 at 11:14am

thanks but i was asking how to make a surface out of it (i changed the title in the meantime realizing it might be confusing)

Permalink Reply by machinehistories on October 31, 2011 at 11:39am

you could treat the legs as three seperate lofted surfaces and the top as a lofted surface - add in a small circle at center of area on the last section curve to extend the size of that surace. This could all be done by organizing the list of curves produced via metaball function. Now you could take the upper edge of the three lofts and offset out and project onto top surface. Split the surface with those projected curves and then you need to create a blend surface from trimmed boundary to the upper edge of the lofts. The blend may need to be done in rhino unless there is a component somebody has made that gives continuity options on a lofted surface. That would be a great tool to have in GH - the blend surface command.

Permalink Reply by Michael Pryor on October 31, 2011 at 11:56am

u need this, http://www.grasshopper3d.com/forum/topics/meshfrompoints-1.

 

Permalink Reply by andreaquartara on March 7, 2013 at 4:52am

Hello!

I can't use meshfrompoint on my Rhino because, even if I put the downoladed files in my software directory there is same problem..I use rhino 5

any help?