how obtain thikness...

Replies to This Discussion

Permalink Reply by Tudor Cosmatu on September 16, 2011 at 10:07am

hi,

not sure if u're talking about this kind of thickness, nevertheless : maybe you can try with meshTchicken from wb, for that you'd have to convert this to a mesh, and have weaverbird installed

Permalink Reply by EmilianoGH on September 16, 2011 at 10:57am

I'm talkin about my structure in the picture:

well, if you see now it's just a thin shit/layer.

 

I would to increase the thikness of this shit ( for example...to make stronger the structure)

 

P.s. I tried to install weaver bird but I can't see it in GH frame

Permalink Reply by RWNB on September 16, 2011 at 11:16am

Permalink Reply by EmilianoGH on September 16, 2011 at 11:27am

this is mine GH frame

 

Permalink Reply by Manuel on September 17, 2011 at 4:12pm

use the brep component to select your geometry in rhino and then the "mesh brep" component to convert the brep into a mesh. Then you can use the wb components (look for the mesh thicken component).

 

 

 

 

Permalink Reply by EmilianoGH on September 18, 2011 at 2:53am

maybe like this?...

 

well:

 

1. how can I regulate the thikness?...with a slider?

2. I would the thikness inside my shape (maybe I have to use a slider with "negative" numbers?)