algorithmic modeling for Rhino
I am trying to run energy simulation using Honeybee.
When I investigate the error, found that in some surface the angle is -1.23432101234e+308 which is out of range. (at line 6155 in attached image)
I tried several way to fix this problem using float or round. However, problem was not solved.
Can anyone know how I can deal with problem?
Tags:
Replies are closed for this discussion.
Hi Katsuya, The Grasshopper forum is no longer used for Ladybug questions. You should post your question to the new Ladybug Tools discourse forum: http://discourse.ladybug.tools/t/welcome-to-ladybug-tools-forum/8
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by