how can i select the nakedVertices?

Replies to This Discussion

Permalink Reply by Mateusz Zwierzycki on December 2, 2011 at 3:42am

Weld mesh with rhino "weld" command before referencing it ;]

Permalink Reply by RWNB on December 2, 2011 at 3:46am

thank you mateusz,

i've also just found the solution!

Command: Weld
Angle tolerance  180

thanks

Permalink Reply by Mateusz Zwierzycki on December 2, 2011 at 3:49am

this was probably the fastest discussion ;) there should be a chat here :D

Permalink Reply by RWNB on December 2, 2011 at 4:10am

i've still some questions. (:

next time.

Permalink Reply by David Rutten on December 2, 2011 at 4:15am

There used to be a chat, but we disabled it. There should be a chat directly in Grasshopper though, I can see that being useful.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by RWNB on December 2, 2011 at 4:20am

(:

Permalink Reply by Mateusz Zwierzycki on December 2, 2011 at 6:12pm

I see it rather as a facebook-effect (just one more talk, post, etc.) :)

Seriously - It should be really well considered (forum would probably die)

Permalink Reply by taz on December 2, 2011 at 6:46pm

GH chat...  how would you ever get anything done?

Permalink Reply by Brian Harms on December 2, 2011 at 7:01pm

@ David

I second that motion