Grasshopper

algorithmic modeling for Rhino

Hover info

Hi, when I used to hover above an icon or in-and outputs, some info came up, so I knew what every icon stood for or what the values were of some in-or output, but now all of a sudden, it stopped doing this. Can I get it back somehow?

 

Thanks,

 

Niels

Views: 328

Replies to This Discussion

Permalink Reply by Chris Ingram on October 19, 2011 at 11:50am

I think a few people have had this problem including myself.

 

You need to 'alt+tab' until you are on 'grasshopper custom tooltip', let go - it will move to first in the panel for switching windows then 'alt+tab' again - then when hovering over it, let go of tab and 'alt+F4' and it should reset it.

Permalink Reply by Fredrik Skåtar on October 19, 2011 at 1:21pm

yeah, all of a sudden it was there again!

I actually opened an old file and then, it started working...

Permalink Reply by Goossens Niels on October 19, 2011 at 2:13pm

Works indeed, thanks a lot!

Permalink Reply by Fredrik Skåtar on October 20, 2011 at 2:50pm

happened again, now I tried alt+tab and alt+F4

It worked but this is strange.

 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service