Grasshopper

algorithmic modeling for Rhino

Honeybee file

Morning Mostapha,

Attached is the honeybee file that i had been using for Annual daylight analysis.  It is giving me some strange error message,see attached. If i change the grid size of the test surface so only 1 pt is running the file will run, if i increase the grid size i get the error.  Any ideas?

Thanks!

Views: 178

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Abraham Yezioro on May 20, 2016 at 11:18am

Jim,

The geometry wasn't internalised.

But in any case i suggest to update the file. There is a small mess with the components. For instance the HB_HB is from 2015 while others are 2016, etc.

-A.

Permalink Reply by jim reisiger on May 20, 2016 at 11:23am

Abraham could you tell me how to internalize the file?

Permalink Reply by Abraham Yezioro on May 20, 2016 at 11:24am

For each component where there is geometry, right click and choose the internalise item from the menu.

-A,

Permalink Reply by jim reisiger on May 20, 2016 at 11:31am

Attached is an updated file with new components and internalized geometry.

Thanks

Attachments:
Permalink Reply by Abraham Yezioro on May 20, 2016 at 11:55am

See a working version.

Yo were missing 2 things: define a glass material and to run the HB_readAnnualResultsI component.

-A.

Attachments:
Permalink Reply by jim reisiger on May 20, 2016 at 12:26pm

Thanks Abraham appreciate the help.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service