Grasshopper

algorithmic modeling for Rhino

Hole Pattern cut out of Geometry's surfaces

I'm trying to make a hole pattern on a multifaceted geometry but I'm stuck as to how to punch out the holes - I've tried a SrfSplit and it takes all the holes and splits them all over the place.  I've attached the file and would greatly appreciate any input! 

Views: 1740

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on September 23, 2015 at 12:09am

Hi.

The easiest way of doing this is using "Boundary Surface" component.

Attachments:
Permalink Reply by Jon on September 24, 2015 at 5:44am

Thanks sooo much for your help - that preview is really cool.  

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service