Grasshopper

algorithmic modeling for Rhino

Hi? I have some simple question about lines Please help me!


I certainly making and also studying grasshopper.

I want to make some curve  which is just simple made of 3 points ,and i have 2 points already but need to find the last point which is what I am looking for. Its is the end of some line but i cannot find the end point of that line.

HOW TO FIND ENDPOINTS OF SOME LINE WHICH ALREADY DRAWN? :(

 

 

in this picture at the top , I want to connect the other end of horizontal line with two ending point of vertical line

 



Views: 494

Replies to This Discussion

Permalink Reply by Evan Bauer on November 15, 2011 at 7:53am

have you tried using the 'end points' component attached to the horizontal line?  then you can take the end points of the horizontal line and connect them to the end points of the vertical lines.  

Permalink Reply by Amaraa on November 15, 2011 at 9:40pm

Thank you very much! I didn't know there was a 'end points' component ^^

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service