Grasshopper

algorithmic modeling for Rhino

hexagonal grid on surface and object placement

I am very new to grasshopper and rhino and I am looking to take a doubly curved surface and put a hexagonal grid on it and then place an object at each of the points generated by the grid. The object must follow the rotation of the surface. Any help with any of these areas would be greatly appreciated. Thank you!

Views: 665

Replies to This Discussion

Permalink Reply by taz on October 24, 2009 at 12:47pm
Megan,

I think the LaN toolkit will have something that can work for you.

http://www.livearchitecture.net/archives/category/code/grasshopper-...

-taz
Permalink Reply by Lý Thanh Hoàng Phúc on October 24, 2009 at 11:26pm
http://www.livearchitecture.net/archives/3299 But it also has a problem, you can't offset geometry in curved surface.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service