Grasshopper

algorithmic modeling for Rhino

Hex Circles - Attractor not working

Hi, my brain is melting trying to figure this out. My MD slider attractor point won't work. It worked before with hexagons cutting hexagons. But now that I added a circle to each hexagon the attractor point won't work.

If I add the nurbs circle to the merge it works fine. But when I try it with a attractor point it fails without any warnings.

GHX attached

THANKS!

Views: 885

Attachments:

Replies to This Discussion

Permalink Reply by Erick Vásquez on December 2, 2013 at 6:44pm

Flatten the Bounds to find the source domain for remap values.

Permalink Reply by Lee Souder on December 2, 2013 at 7:01pm

Ah, thank you Erick that worked! But the circles are adding geo instead of cutting out. Any ideas?

Attachments:
Permalink Reply by Erick Vásquez on December 2, 2013 at 7:15pm

merge in order

Permalink Reply by Lee Souder on December 2, 2013 at 7:27pm

thank you thank you thank you!!!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service