Grasshopper

algorithmic modeling for Rhino

Help With Surface from points

Hello!

I am trying to make a surface from a set of points, I've tried creating polylines from those points and lofting those, but that still doesn't work. I think the issue there is due to two different line types "Polyline Curve and Line-Like Curve". Is there any way to make these curves the same so I can loft them, or make a surface from the set of points. I haven't had much luck with the the "surface from points" component so if anyone could offer some help it would be greatly appreciated.

Thank you for your help,

-Andrew

Views: 227

Attachments:

Replies to This Discussion

Permalink Reply by nikos tzar on April 5, 2015 at 5:09pm

Hello Andrew,

The problem is that you start with 3 surfaces, so when you create the grid of points you have duplicate points where the surfaces meet.

You can either create 3 surfaces again, or remove 2 rows of points to avoid duplicates and then create one surface:

Attachments:
Permalink Reply by Andrew Cook on April 5, 2015 at 5:16pm

Thank you Nikos! That worked perfectly you guys are geniuses on here.

I really appreciate your help!

-Andrew 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service