Help with dividing a surface

Replies to This Discussion

Permalink Reply by TheChosenOne on October 18, 2012 at 11:24pm

Permalink Reply by david mimran on October 19, 2012 at 4:19am

Thanks for your response, 

The solution you propose only creates a smaller box to be divided but does not use the specified shape as the perimeter for the division. Is there a way of constraining the division by the proposed form??

any advice will be very much appreciated! 

David 

Permalink Reply by TheChosenOne on October 19, 2012 at 4:48am

Then you need to remodel your surface with this command

Permalink Reply by david mimran on October 19, 2012 at 9:04am

it worked! thanks for you help!!!

Permalink Reply by djordje on October 19, 2012 at 9:26am

Thechosenone, which command are you pointing out? The "Surface from network of curves?"
Does that mean that we need to extract the edges of the surface first and then to make a new surface out of them?
But for some reason I could not do that with a surface that has somewhat circle edges:

Any help?

Attachments:

• divide2.gh, 1 KB
• divide2.3dm, 79 KB

Permalink Reply by TheChosenOne on October 19, 2012 at 10:23am

Yes, yes. You understand me correctly, circle edges must be cut into four pieces, and the only way to get untrimmed surface.

And also the grasshopper has no command "NetworkSrf". On this work the old way - by hand.

Permalink Reply by djordje on October 19, 2012 at 12:21pm

Thank you Neo :)
I was not aware that "NetworkSrf" is such powerful tool, until today.

Works great.

Permalink Reply by TheChosenOne on October 19, 2012 at 10:37am

David, as I understand it, need a something like this.

Permalink Reply by david mimran on October 20, 2012 at 12:23pm

exactly! 

Thanks for your help and advice!

David 

Permalink Reply by Apostol Răzvan Florin on October 24, 2012 at 2:23pm

i have a great issue here.. i cant rebuild my surface.. i will upload my trimmed surface.. and if someone can rebuild it and show me how he did it i will eat my mouse. thanks in advice

Attachments:

• trimmedsrf.3dm, 127 KB

Permalink Reply by djordje on October 24, 2012 at 5:18pm

I tried to make the same surface with "NetworkSrf" command but the result is corrupted.
Sorry somebody else may try to help you.

Permalink Reply by Apostol Răzvan Florin on October 25, 2012 at 12:21am

thanks djordje >:D< no problem, i got the same results as you got with netsrf :(.

• ‹ Previous
• 1
• 2
• Next ›
• Page