Help me plzzzz

Replies to This Discussion

Permalink Reply by leeuack on January 8, 2014 at 1:48am

the yellow lin is what i want to draw

(the yellow line was created in rhino)

Permalink Reply by David Rutten on January 8, 2014 at 3:20am

Hi leeuack,

the file you posted uses a PanelingTools component which I do not currently have installed. also the bottom most curve parameter references an object which is not in the 3DM file.

However I wonder if what you are after is merely the yellow line based on the diagonal line and a number of steps. If so, this can be done a lot simpler.

--

David Rutten

david@mcneel.com

Permalink Reply by David Rutten on January 8, 2014 at 3:26am

--

David Rutten

david@mcneel.com

Attachments:

• Stairs.gh, 5 KB

Permalink Reply by leeuack on January 8, 2014 at 4:43am

actually what i want to do is make stairs with 2 parameter; height crv and length crv

because at the initial process of design building i just need simple stairs.

 anyway thnk you so much David.

 

p.s : how do i pick a point from point list?

Permalink Reply by leeuack on January 8, 2014 at 5:01am

this is what i try to do....T..T

Permalink Reply by Nick Tyrer on January 8, 2014 at 5:02am

Digital toolbox has some good introductory videos to get you started. 

http://digitaltoolbox.info

Specifically for this question you want the 'list item'.

http://digitaltoolbox.info/grasshopper-basic/list-item/

Permalink Reply by leeuack on January 8, 2014 at 5:08am

wow...thanks Nick

Permalink Reply by David Rutten on January 8, 2014 at 5:03am

If you connect the end-points of those two curves and feed the resulting line into the algorithm I posted you'll get that result.

--

David Rutten

david@mcneel.com

Permalink Reply by leeuack on January 8, 2014 at 5:10am

i understood

i had never thought to use the project componet.

thank you David