Help for FACADE !!! Urgent...

Hello Everybody,

Need Help to Generate the facade exactly with the profile curves and the boundaries.

When i try to Patch them I get this very irregular Surface, you can see it in the file.

Find Attached the Rhino File Facade work.

Any help will be Appreciated.

ITS URGENT !!!!

Thanks.

Shaique

Attachments:

Facade work.3dm, 471 KB

Replies to This Discussion

Permalink Reply by David Rutten on September 14, 2012 at 8:11am

What's the input? How is it generated? What should the facade look like?

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by mohammad shaiqueuddin on September 14, 2012 at 8:40am

Actually The First Sketch was developed in Maya... and as you may know that in maya whenever you smooth the model... It goes away from the original line...

So then I Exported the model Cut the all the floors...the thing is that the Top twelve floors are typical... So practically the facade should come all the way straight till this floors...and then it should start bending down the line as it approached the ground...So these are the Parameters and I have already Put all the Crvs for the Same...the trick is at the rear side of the facade...where the curves suddenly start coming out... making it very difficult to control the smooth seam of the surface....

RSS